carlsthebest
New Member
- Messages
- 2
hi all ive just got this welder and all works except controll of wire feed speed, its too fast and doesnt go up or down ive tested the controll and get 0 - 9kohm range so that is fine so must be the pcb but ive also put a new 100ohm resistor on r01 as that had blown and a 697 on r26 as that wasnt blown but tested it as it was burnt so put the same back.
also when i select volts to 6 it blows my electric whats that about its on its own dedicated 32 amp socket
please could someone tell me what is the problem
also when i select volts to 6 it blows my electric whats that about its on its own dedicated 32 amp socket
please could someone tell me what is the problem