Tommyf
Member
- Messages
- 100
Merry Christmas all,
I wondered any one can give me some advice please,
I bought a secondhand Migmatic 250 DX just before Christmas and I’m not getting to much info from the instructions on how to set it up in synergic mode .
Can anyone tell me where the dials need to be for the voltage and wire feed speed for different thickness of steel , I was hoping there would be a chart of some sort behind the door but unfortunately there is not. Or does it sort all this out itself?
The other thing I’ve noticed is that the gun only works as 2t when its in 2t or 4t mode Any thoughts with that one ?
Any many thanks in advance.
All the best
Tom
I wondered any one can give me some advice please,
I bought a secondhand Migmatic 250 DX just before Christmas and I’m not getting to much info from the instructions on how to set it up in synergic mode .
Can anyone tell me where the dials need to be for the voltage and wire feed speed for different thickness of steel , I was hoping there would be a chart of some sort behind the door but unfortunately there is not. Or does it sort all this out itself?
The other thing I’ve noticed is that the gun only works as 2t when its in 2t or 4t mode Any thoughts with that one ?
Any many thanks in advance.
All the best
Tom