Migtronic 180 no wire feed

  1. Johncvmc New Member

    Messages:
    2
    Location:
    North wales
    hi wounder if someone can help me when you turn on green light comes on front but nothing happens when you pull trigger. It’s not the torch that works fine on other welder.
     
  2. ndg Member

    Messages:
    53
    Location:
    Warwick, UK
    Any gas flowing?
     
  3. w124 Member

    Messages:
    103
    Location:
    poland
    check all connections, i had some problems with water cooled mig torch. ground clamp was in place but it was pulling out wire without effect. but the light actually flashed yellow, and it wasnt a migatronic. despite the fact the water hoses were connected propely, but taking them out and re-inserting makes it work for me, and its a quite common issue that happens once a month or 2 at least on that unit, but there was one that wasnt reacting on the wire feeder too and it was a Sincosald, dont remember what exactly been the issue but it had some connection issues that didnt let the feeder roll.
     
  4. Johncvmc New Member

    Messages:
    2
    Location:
    North wales
    Sorry for late reply no there’s no gas flow
     
Advertisements