Exuptoy
Member
- Messages
- 2,878
- Location
- Maesteg, South Wales
I have purchased a damaged exhaust for my Street Triple which had been down the road. I managed to remove the end cap and straighten it out but now need an end trim cap to finish it off.
Looking for it to be made in stainless to fit inside a 94mm ID void with a lip approximately 15mm long to go inside the wall, through which I will be bolting or rivetting, with a Motor GP style slash cut end maybe 70mm OD and 60mm long. I can trim the ends fore and aft to suit the can before fitting.
I realise the one below is of different dimensions but something similar to this end cap would be great.
It has to fit this.
I will cover any costs/time.
Looking for it to be made in stainless to fit inside a 94mm ID void with a lip approximately 15mm long to go inside the wall, through which I will be bolting or rivetting, with a Motor GP style slash cut end maybe 70mm OD and 60mm long. I can trim the ends fore and aft to suit the can before fitting.
I realise the one below is of different dimensions but something similar to this end cap would be great.
It has to fit this.
I will cover any costs/time.