I recently acquired a minimig 180. It's great
Although I've noticed that on the higher amp settings - 8,9, 10. It occasionally pops the breaker.
I remember at my old house (and SIP 130) I swapped the 16A Type B for a type D.
but I would have thought a 32A breaker has enough headroom to run a 180amp MIG without needing the type D?
Something else I've noticed is that it always happens on first pull of the trigger.. never once you start welding.
Are there any other potential causes?!
Although I've noticed that on the higher amp settings - 8,9, 10. It occasionally pops the breaker.
I remember at my old house (and SIP 130) I swapped the 16A Type B for a type D.
but I would have thought a 32A breaker has enough headroom to run a 180amp MIG without needing the type D?
Something else I've noticed is that it always happens on first pull of the trigger.. never once you start welding.
Are there any other potential causes?!