hermetic
Member
- Messages
- 471
Hi all, just bought this welder, and wondered of anyone has an instruction manual kicking about in a drawer, or can tell me what the controls do! Most are obvious, but some of the symbols are it bit ambiguous to say the least
View media item 9250
AC/DC and the current switches are obvious, but the dial in the centre below the yellow danger/electric flash appears to show a setting for different tungsten diameters? The three controls acros the top also a bit baffling, left one is a three position switch, and right one could be upslope on/off? Large white knob at the bottom was said to be Voltage control, and I note this has a hole next to it which I will investigate further tomorrow. The good news is it is in working order, the bad is that I wont be able to play till I get a gas bottle, regulator and some filler rods and consumables, but this is actually good, because the most important thing at the moment is the workshop roof!!!
Any help aprreciated, I am a long time self taught welder on stick, gas and mig, but never touched Tig in my life. I will be browsing your tutorials!
Phil
View media item 9250
AC/DC and the current switches are obvious, but the dial in the centre below the yellow danger/electric flash appears to show a setting for different tungsten diameters? The three controls acros the top also a bit baffling, left one is a three position switch, and right one could be upslope on/off? Large white knob at the bottom was said to be Voltage control, and I note this has a hole next to it which I will investigate further tomorrow. The good news is it is in working order, the bad is that I wont be able to play till I get a gas bottle, regulator and some filler rods and consumables, but this is actually good, because the most important thing at the moment is the workshop roof!!!
Any help aprreciated, I am a long time self taught welder on stick, gas and mig, but never touched Tig in my life. I will be browsing your tutorials!
Phil