frank horton
V twins are great but 4"s rule.........
- Messages
- 3,843
- Location
- Crete, Greece
right,
have 2 abrasive chop saw's that will go to pay towards an Industrial type 355mm metal blade chop saw......
110v Makita and a 240v..+ loads'a new disc's.....
......
bogged down on the reviews.......
need a quick release screw clamp and what else.......??????? I'm always cutting at 45deg
general veiws needed.......as in whats best value.......
this is not used everyday but soon have to make 50 @ 10mm thick plates with a radius corners.....
it takes to long to use the 12" band saw and the abrasive chop saw's dont cut square over the depth on the corner cuts.......
plus it'd be handy on site especially as I wont need to carry extra abrasive disc's all the time....
what d ya think ?
many thanks
have 2 abrasive chop saw's that will go to pay towards an Industrial type 355mm metal blade chop saw......
110v Makita and a 240v..+ loads'a new disc's.....
......
bogged down on the reviews.......
need a quick release screw clamp and what else.......??????? I'm always cutting at 45deg
general veiws needed.......as in whats best value.......
this is not used everyday but soon have to make 50 @ 10mm thick plates with a radius corners.....
it takes to long to use the 12" band saw and the abrasive chop saw's dont cut square over the depth on the corner cuts.......
plus it'd be handy on site especially as I wont need to carry extra abrasive disc's all the time....
what d ya think ?
many thanks