Benterrier
Member
- Messages
- 140
- Location
- UK Hereford
Hi Guys
New to the Forum. I Have a old Triangle single phase with virtually no marking or paint on it. The aluminium Amp indicator plate has no visible signs, just white powder dust, I can just make out High and Low markings on the top edge.
Looking at the welder from the front the earth lead disappears through a hole to the inside. I have 2 top terminals, one positioned left and the other right, The welding lead has always been attached to the top left terminal. I have swopped the leads over and welds the same with no apparent difference, would this be DC terminal, I am using 6013 2.5 3.0mm rods and can get nice runs.
Any pictures of the beast in better condition or identification of the 2 terminals would be great.
Regards
New to the Forum. I Have a old Triangle single phase with virtually no marking or paint on it. The aluminium Amp indicator plate has no visible signs, just white powder dust, I can just make out High and Low markings on the top edge.
Looking at the welder from the front the earth lead disappears through a hole to the inside. I have 2 top terminals, one positioned left and the other right, The welding lead has always been attached to the top left terminal. I have swopped the leads over and welds the same with no apparent difference, would this be DC terminal, I am using 6013 2.5 3.0mm rods and can get nice runs.
Any pictures of the beast in better condition or identification of the 2 terminals would be great.
Regards