Looks like I'm going to have to modify the dedicated circuit into garage. It already has a 6mm cable with a
32 amp MCB but 13amp socket and plugs. What do I need to do bring this up for the supposed 50 amps of a plasma cutter. It normally runs on 120V but has auto detection for 220, if its the matter that the wattage remains constant at a particular setting then the amperage in the supply is reduced I cannot find a reference to that, but even so I still need to modify the circuit, what do I need for this?, fortunately I do not run the compressor of the same circuit.
Bert
32 amp MCB but 13amp socket and plugs. What do I need to do bring this up for the supposed 50 amps of a plasma cutter. It normally runs on 120V but has auto detection for 220, if its the matter that the wattage remains constant at a particular setting then the amperage in the supply is reduced I cannot find a reference to that, but even so I still need to modify the circuit, what do I need for this?, fortunately I do not run the compressor of the same circuit.
Bert