I'm replacing a very small section on a lower quarter panel and am struggling to get my panel matched up.
I think I know what I need to do... Its the how to do it???
My tools are limited to a few dolly's and selection of hammers. I've managed to get the majority of shape by using my comma dolly as a form and then shrinking the tighter curve.
Th real issue I'm having is trying to put my next curve into the panel as I need to bring the lower edge inwards while maintaining the lip?
Pretty sure this will involve shrinking a bit more near the arrows but really stumped on how I can do this with the tools at my disposal?
Would greatly appreciate any pointers... Before I run out of metal lol
T.I.A - omar
I think I know what I need to do... Its the how to do it???
My tools are limited to a few dolly's and selection of hammers. I've managed to get the majority of shape by using my comma dolly as a form and then shrinking the tighter curve.
Th real issue I'm having is trying to put my next curve into the panel as I need to bring the lower edge inwards while maintaining the lip?
Pretty sure this will involve shrinking a bit more near the arrows but really stumped on how I can do this with the tools at my disposal?
Would greatly appreciate any pointers... Before I run out of metal lol
T.I.A - omar