Hello

[alistairlee]

Hi
Just bought an Aldi gasless cheapo because I've always wanted to try MIG welding but could not justify the cost (still can't but well she's not seen the CC bill yet
Was able to do very basic Gas welding on the bench 30 ish years ago -so I'm sure I know what a good (very average) joint should look like
Thanks in advance for the help I'm sure I'll need.
Regards
Al

 

[zardoz]

Hello there. If you can master the cheap gasless then a proper gas mig will probably be easier, if you ever try. Remember to use some "anti spatter" spray it will save on chipping of the spatter later. Also remember to weld with a pull stroke when using gasless.

 

[Dusty]

You'll probably find it's very like stick welding only on a roll!!!!!!!

 

[alistairlee]

Hello there. If you can master the cheap gasless then a proper gas mig will probably be easier, if you ever try. Remember to use some "anti spatter" spray it will save on chipping of the spatter later. Also remember to weld with a pull stroke when using gasless.

Thanks for this tip, I would have tried it the opposite way.

Al