God mode restorations
Member
- Messages
- 8,092
- Location
- uk colchester
Morning guys.
Anyone no where I can get an mt2 headstock spindle centre from.
Anyone no where I can get an mt2 headstock spindle centre from.
Morning guys.
Anyone no where I can get an mt2 headstock spindle centre from.
Ok cheers.I might have a spare, Spencer. I'll have a look a bit later.
My spindle has an mt2 taper.Are you looking for a centre or a spindle?
If it's a centre then the usual suspects rdg tools or chronos. If it's a spook ndle for what lathe?
Is it an mt2 dead centre you need.Morning guys.
Anyone no where I can get an mt2 headstock spindle centre from.
more than likely u wouldn't need a rotating one in the head stock mainly used for turning between centres using a dog and catchplateIs it an mt2 dead centre you need.
I thought as much but was not sure because he was asking where to get one from. Mt2 Dead centres are common as muck. I’ve got at least 3. That’s why I asked.more than likely u wouldn't need a rotating one in the head stock mainly used for turning between centres using a dog and catchplate
Yes. But the headstock one is hugedead centers 2mt are 2 a penny available from most places https://www.tracytools.com/lathe-tooling/lathe-centres
Is it an mt2 dead centre you need.
u did say in your post it is 2mt what u require is a reducer sleeve to a no 2 mt from whatever your headstock bore size is there all differentYes. But the headstock one is huge
Yes. But the headstock one is huge
he wants a spindle sleeve reducer down to mt2 from whatever the lathe bore is
I DID put a l;ink in my earlier post no 10 for a no 2mt center pay attention .there no science in it look at post 11 as wellThe spindle bore is MT2. He wants an MT2 centre. It's not rocket science
pay attention .there no science in it look at post 11 as well