I understand this has been coverd in preveose posts but I did not see any conclusion.
IV a genset as above its never mised a beat untill about a month ago I was using a 9 inch grinder it seemed to peek then lose all output when I say peak It just for a second made the grinder run faster ? The engine is running fine at the corect rpm ? IV lost all output from the welder and am getting about 6v from all the electric outlets 110 240 and 3 phase I'm getting 6 v from all three phases The capasitores are huge three pin things linked together with alloy straps they look ok nothing poped ? I will test them but don't know where to start I understand that I need to disconnect them after discharging them ? But WHER do I take the readings from ? Any help please thanks Adam
IV a genset as above its never mised a beat untill about a month ago I was using a 9 inch grinder it seemed to peek then lose all output when I say peak It just for a second made the grinder run faster ? The engine is running fine at the corect rpm ? IV lost all output from the welder and am getting about 6v from all the electric outlets 110 240 and 3 phase I'm getting 6 v from all three phases The capasitores are huge three pin things linked together with alloy straps they look ok nothing poped ? I will test them but don't know where to start I understand that I need to disconnect them after discharging them ? But WHER do I take the readings from ? Any help please thanks Adam