mowersman
Member
- Messages
- 252
- Location
- Somerset, UK
Afternoon all
I am considering having some galvanising done, but looking for some advice on how much distortion I am likely to encounter, before proceeding.
The bits I have are Land Rover door frames and sill/B post/C post assemblies. Both are made of pressed steel channels and box section. Both are fairly thin, I would guess 1.2mm for the door frames, 1.5 on the sill assemblies.
Any thoughts?
Cheers
Andrew
I am considering having some galvanising done, but looking for some advice on how much distortion I am likely to encounter, before proceeding.
The bits I have are Land Rover door frames and sill/B post/C post assemblies. Both are made of pressed steel channels and box section. Both are fairly thin, I would guess 1.2mm for the door frames, 1.5 on the sill assemblies.
Any thoughts?
Cheers
Andrew