blackolive (Ste)
Member
- Messages
- 1,349
- Location
- Chorley
I need to make a terminal cover to replace a missing one on an antenna rotator Ive bought.
Its only a small thing 80x30x15mm, unfortununately I cant find an ABS electronics enclosure thats a near enough size.
Im thinking to make a wooden mould ( with a bit of draft on the edges) and laying a few coats of CSM over it to make a cover.
Ive had a look online at mould release agents most seem to be PVA or wax based.
Ive some ronseal finishing wax, or some hard car wax, will a few coats of this do the trick ?
Its only a small thing 80x30x15mm, unfortununately I cant find an ABS electronics enclosure thats a near enough size.
Im thinking to make a wooden mould ( with a bit of draft on the edges) and laying a few coats of CSM over it to make a cover.
Ive had a look online at mould release agents most seem to be PVA or wax based.
Ive some ronseal finishing wax, or some hard car wax, will a few coats of this do the trick ?