E Enyap1 New Member Messages 1 Location England Nov 26, 2018 #1 Hi I'm new to all this I have the draper mw135at My wire keeps getting stuck then backs up on itself. I have taken the liner apart and can't see any damage to the wire liner. Do I need a new torch and liner?
Hi I'm new to all this I have the draper mw135at My wire keeps getting stuck then backs up on itself. I have taken the liner apart and can't see any damage to the wire liner. Do I need a new torch and liner?
rtbcomp Moderator Messages 18,575 Location Sheffield UK Nov 27, 2018 #2 Welcome to the forum. Do you mean it forms a birds-nest between the rollers and the start of the liner? Is the welder new or 2nd hand?
Welcome to the forum. Do you mean it forms a birds-nest between the rollers and the start of the liner? Is the welder new or 2nd hand?
T Tom O Member Messages 612 Location Canada Nov 27, 2018 #3 Could it be not unrolling properly the wire might be overlapped. I had this happen and suspended the roll letting it unwind till good.
Could it be not unrolling properly the wire might be overlapped. I had this happen and suspended the roll letting it unwind till good.