steve.h
Fire Starter,,,,
- Messages
- 348
- Location
- swindon sn4
Me again, I have questions on the best way to cut detailed shapes fron sheet steel for a project I will be doing. It will be about 1.5 - 2 mm thick sheet, I want to cut out a silhouette of my 4x4 for putting on my gates.
The only tools I have at the moment are an angle grinder, drill and jigsaw. Is there a drill bit or a jigsaw blade a bit like a tile hacksaw blade (basicly a 2 or 3 mm rod with abrasive material on it) so that I can then cut in all directions for cutting curves etc, ive always found the normal jigsaw blades hard to get nice smooth curves.
all input is very welcome.
cheers.
steve.h
The only tools I have at the moment are an angle grinder, drill and jigsaw. Is there a drill bit or a jigsaw blade a bit like a tile hacksaw blade (basicly a 2 or 3 mm rod with abrasive material on it) so that I can then cut in all directions for cutting curves etc, ive always found the normal jigsaw blades hard to get nice smooth curves.
all input is very welcome.
cheers.
steve.h