weldingnovice
Member
- Messages
- 254
- Location
- Northeast
I have a few spare engines in various states of repair for 85/86 YZ250. Cranks in useable condition are now becoming rare. This engine was losing crankcase pressure round oil seal behind stator plate.
Could this be tig welded then re ground?
Any ideas on best options for repair and ball park figure on this would cost? Read somewhere about metal spraying?
I am NE England so should be relatively cheaper than most other places
Could this be tig welded then re ground?
Any ideas on best options for repair and ball park figure on this would cost? Read somewhere about metal spraying?
I am NE England so should be relatively cheaper than most other places