Converting Clarke Gasless 135en

[OrionGav]

Hi
I'm sure this has been asked hundreds of times so i will apologise in advance but could some of you people point me in the right direction of what is needed to convert my Gasless Clarke mig 135En?

I'd rather use bigger gas bottles than the small ones.
Regards
Gav

 

[mike 109444]

look down the list and you should find a reg and convert pipe kit. You will need to decide if you are going to use CO2 only or Argon+CO2 mix as the connections on the bottles is different so regs are different
http://www.weldequip.com/regulators-gas.htm
And welcome BTW

 

[angellonewolf]

and dont forget to change the plority round in where the wire goes you should have 2 knobs marked above + and -

 

[OrionGav]

Thanks for the replies people, mainly going to be used for car body work and maybe the odd other thing so i'm assuming c02/argon mix would be best?
Thanks