Im trying to use my clarke 110EN dual purpose welder...with 0.9mm fluxed wire..
Im practising on a VW Beetle (1970's) wing, and finding that if i set the wire speed over 3, it blows holes! The instructions say 5-6, but i cant go past 3 (thats for 0.6-0.8mm mild steel) Im on lowest power setting also.
I would guess the wing is 1.2mm thick mild steel.......or there abouts...
Anyone have any tips?
Also, when its set at 3, with min power, my welds seem too flat....
HELPPPPP!!
Im practising on a VW Beetle (1970's) wing, and finding that if i set the wire speed over 3, it blows holes! The instructions say 5-6, but i cant go past 3 (thats for 0.6-0.8mm mild steel) Im on lowest power setting also.
I would guess the wing is 1.2mm thick mild steel.......or there abouts...
Anyone have any tips?
Also, when its set at 3, with min power, my welds seem too flat....
HELPPPPP!!