shenion
Tool Pack Rat
- Messages
- 7,586
- Location
- Stone Mountain, GA USA
I saw posts on using PVC pipe for TIG rods and made some out of some 1 1/4" pipe.
Decided to to the same for my arc rods. Used 2" PVC pipe. Really wanted square end caps, but all I could find are round ones:
Frame is 3/4" steel box. Had to build something, these tubes kept rolling around The 7018 tubes will have silica gel packs in the bottom to keep dry.
2" PVC will just hold 5 lbs of rods. Cost about $20.
Decided to to the same for my arc rods. Used 2" PVC pipe. Really wanted square end caps, but all I could find are round ones:
Frame is 3/4" steel box. Had to build something, these tubes kept rolling around The 7018 tubes will have silica gel packs in the bottom to keep dry.
2" PVC will just hold 5 lbs of rods. Cost about $20.