Kram
Member
- Messages
- 6,223
- Location
- Sussex
I didnt want to make the Sherman thread any longer, there is a lot of good information in there and I expect to read through it again, Im up to page 18. Feel free to post in this thread if you have a question about what to buy or about buying one.
I have sent my payment by Paypal, used my cards exchange rate as its much better and no fee on this card. I sent a bit extra But much better the shop get extra than paypal getting it
I wanted to check what Ive ordered. I want to learn on mild, stainless, aluminium and copper, probably more on turned /milled parts and 0.8-1mm sheet.
Ordering red tungstens 1, 1.6, 2, 2.4 and 3.2mm, couple of each and this set of bits. Do I need any others?
https://weldes.co.uk/gb/tig-consumables/197-tig-51-pcs-sr17-sr18-sr26-set.html
I have stainless and 5356 alu and steel mig wire I was intending to practise with if thats usable, or should I buy the proper rods to begin with?
I'd like to buy CuSi3 brazing wire/rods but its not available in small amounts? So can I use electrical wire as filler? I have plenty.
Thanks!
I have sent my payment by Paypal, used my cards exchange rate as its much better and no fee on this card. I sent a bit extra But much better the shop get extra than paypal getting it
I wanted to check what Ive ordered. I want to learn on mild, stainless, aluminium and copper, probably more on turned /milled parts and 0.8-1mm sheet.
Ordering red tungstens 1, 1.6, 2, 2.4 and 3.2mm, couple of each and this set of bits. Do I need any others?
https://weldes.co.uk/gb/tig-consumables/197-tig-51-pcs-sr17-sr18-sr26-set.html
I have stainless and 5356 alu and steel mig wire I was intending to practise with if thats usable, or should I buy the proper rods to begin with?
I'd like to buy CuSi3 brazing wire/rods but its not available in small amounts? So can I use electrical wire as filler? I have plenty.
Thanks!