FlyByNight
Eco-Warrior
- Messages
- 15
Hi Everyone,
This isn't quite my first post here but I guess it's time for a formal introduction.
I just bought my first welder and I am hoping to start creating wind turbines and water turbines. Of course I have a lot of practicing to do before I let myself loose on anything that will spin at high velocities!!
I bought a Mac MW140ET MIG welder that was advertised on eBay and haven't had a chance to try it out yet. I pulled the case off it this morning and all looks well inside. The wire feed works well and I am hoping that everything else does too. All will become clear when I get my hands on some gas and give it a try.
I'm sure I'll have loads of questions as I progress so watch out!
Cheers, FlyByNight
This isn't quite my first post here but I guess it's time for a formal introduction.
I just bought my first welder and I am hoping to start creating wind turbines and water turbines. Of course I have a lot of practicing to do before I let myself loose on anything that will spin at high velocities!!
I bought a Mac MW140ET MIG welder that was advertised on eBay and haven't had a chance to try it out yet. I pulled the case off it this morning and all looks well inside. The wire feed works well and I am hoping that everything else does too. All will become clear when I get my hands on some gas and give it a try.
I'm sure I'll have loads of questions as I progress so watch out!
Cheers, FlyByNight