Hello all,
Have been looking around the forum. Had originally wanted to start learning to tig but costs etc put it out of my reach at the moment.
Anyway I have been looking for arc/mig welders not sure which route to go. I have mig welded in the past... not brilliant but not too bad. My previous job working on HGVs meant I did abit now and again.
I would like to get hold of an arc welder. Mainly for just messing around in the garage. And if I get decent enough would like to fabricate some new gates for the house.
Is there any brands you would recommend and any to avoid? Also what settings/ features should I look out for. It will need to run off a 13amp house supply.
Many thanks and sorry for the rambling on.
Kris
Have been looking around the forum. Had originally wanted to start learning to tig but costs etc put it out of my reach at the moment.
Anyway I have been looking for arc/mig welders not sure which route to go. I have mig welded in the past... not brilliant but not too bad. My previous job working on HGVs meant I did abit now and again.
I would like to get hold of an arc welder. Mainly for just messing around in the garage. And if I get decent enough would like to fabricate some new gates for the house.
Is there any brands you would recommend and any to avoid? Also what settings/ features should I look out for. It will need to run off a 13amp house supply.
Many thanks and sorry for the rambling on.
Kris