anyone got a wiring diagram for a migatronic 231?

  1. arther dailey

    arther dailey Member

    Messages:
    3,980
    Location:
    England
    been asked to look at a mates migatronic 231, welds fine from power 5 upwards,good penetration , where as below that weld tends to sit on top rather than penetrate,tried it on some 1mm and a bit stuttery and poor,whereas on 4mm it works fine on p.5. suspect capacitor(S) ,any info welcomed .thanks Arther
     
  2. Rig Pig

    Rig Pig Member

    Messages:
    3,754
    Location:
    Narrwich! U.K.
    I did the capacitors in my 180 a few years ago, if its the capacitors at fault then it should be fairly obvious once the side is off the machine, mine were all leaking and looked a right mess. I put a post on here with some pictures.
     
  3. arther dailey

    arther dailey Member

    Messages:
    3,980
    Location:
    England
    had a quick look, visually they look brand new,no swelling or rust/dodgy connections,reckon I will have to pull em out and test when I get spare minutes,thanks for the interest,appreciated.
     
    Rig Pig likes this.
Advertisements