Adam Marshall
Member
- Messages
- 489
- Location
- Nottinghamshire England
My usual welding requires me to weld 3mm and 4mm steel 2m runs at a time with 1mm wire. My neighbour looked at me gone out is anyone else using 1mm wire for 3mm steel?
3mm what's wrong with an arc welder?
Just a thought..
I know this is the mig welding forum...That’s not a bad shout. I probably ought to do that. I really enjoy arc actually, but the mig is just so handy - just turn on the gas, turn on the welder and away we go!
If you where butt welding sheet I would be in the 0.8 camp but if it’s all fillets then the 1.0 may win depending on fit up etc.
Its all fillet welds
we run 1.0mm for everything.