RaceDiagnostics
Forum Supporter
- Messages
- 2,891
Wasn't sure how to remove this shell as access to the backside is obscured, so levered it with a screwdriver.
...and the rollers fell out but the inner race didn't budge.
So welded on two bars, the idea was to support with the bars the tap down on the spindle.
That did not go well, light tapping changed to large hammer till the welds broke.
I'm now thinking cut off with a dremmel?
Any more suggestions?
...and the rollers fell out but the inner race didn't budge.
So welded on two bars, the idea was to support with the bars the tap down on the spindle.
That did not go well, light tapping changed to large hammer till the welds broke.
I'm now thinking cut off with a dremmel?
Any more suggestions?