PREILLY1317
New Member
- Messages
- 1
- Location
- Birmingham
Hi,
I need to buy and weld some 50mm thick base plates, which I will they weld to columns. The base plates need holes and slot putting in them. I was looking to get the plate shaped and holes/slots profiled at the same time. Is this acceptable under BSEN 1090 exc class 2 ? Or do the holes / slots need to be machined so their are no hard spots etc?
Thank
Phil
I need to buy and weld some 50mm thick base plates, which I will they weld to columns. The base plates need holes and slot putting in them. I was looking to get the plate shaped and holes/slots profiled at the same time. Is this acceptable under BSEN 1090 exc class 2 ? Or do the holes / slots need to be machined so their are no hard spots etc?
Thank
Phil