Is it possible to get a copy of the above software? if anyone can help i would be most gratefull ;) i would buy a copy but ive lost my job and then the same happened to the missus so money a tad tight to say the least :(
Please pm me if you can help.
Kindest regards Lee
Worst thing ive seen was a lad on youtube using a 2 post lift and with the engine fired up and in gear used the cars own spinning wheels to refurb the edges and eventually polish the rims ;) looked good at the end but bloody dangerous way to work :(
Ah found it ...
Before re fittting the drum m8 get a wire attachment on ya drill and clean all the mating faces up till the metal is like new ;) also make sure you remove any lip off the drum caused by wear to save future heartache and use copper slip,ive been on more abs/brake fitting course`s that i care to...
Ive got a similar welder to urs m8ty and also just started learning,for 1-2mm thick stuff i find putting all the switches up and wire speed 5-6 works ok with argon/co2 mix ;)
What gas are you using by the way?
lee
Thanks peeps for the kind words,yup i find the little clarke a handy tool for what i need it for(car body repair,when im good enough) i added a case fan off a pc to it for extra cooling so i guess i can call it a clarke 100e TURBO :laughing:
I did do a couple of welds with the chuck away gas...
Well after much reading on here and setting up my clarke 100e MK2 with full size argon/co2 bottle and reg i began to play :whistle:
Enjoyed myself so much i nearly missed my meal date with the wife lol (her birthday)
So heres the pics for the pro`s on here pi$$ taking lol ,be gentle eh lol