Lads. Thanks for the advice so far. Any chance of sending me a private message to give me some idea of the cover you have and what i should expect to pay?
Regards
Hello
Can anyone give me information of the type of insurance i will nee for any hot-work ie welding, cutting, grinding?
I'm looking to work on customer sites building stainless steel skids and frames.
Guessing i need cover in-case i burn any building down, damage anything etc
Any info...
I have an elderly WC RollAir 500 (i think this is the model as there is no ID plate fitted).
Three phase - 60cfm
Three phase supply. 24v pressure switch.
Had someone in to rewire the compressor. They started the job but never returned so at the moment i have a rats nest of wiring without the...
Thanks for all your feedback.
Anything from 35-75 amps it is crap, and as someone mentioned it will also flash which adds to the 'joy'.
Have tried lamps and they make little or no difference to the situation.
optima21 - i have looked at your link and they look like another low-end product but...
Any answers to this annoying problem?
The helmet i have is certainly at the cheaper end of the market, and has a range of 9-13 but i'm struggling to see the weld area clearly. By that i mean the area remains too dark to weld properly. I have tried on the lightest setting and it's next to...
Justin. Don't wan't to appear rude but do you have any answers to the few questions i have asked?
Are you familiar with the set i have, or have experience of welding different types of aluminium?
I am on this Forum to make contact with experienced welders as they have the answers, but
thanks for...
Background:
No welding experience to speak of but making a little progress through trial & mainly error with mild/stainless.
After some basic information, and some base settings for a variety of aluminium (and s/steel if you feel inclined) welding please. Looking for what has worked in real...
Hello
At the moment i'm welding mainly stainless to stainless and the heat marks made by the process need to be removed. What product would be best for this?
Also, welding some small steel engine parts but the welds are left sooty. I have sweated oil from the parts to be welded but i'm guessing...
Thanks to all for the quick replies.
To Paul as you have experience of this type of work - very new to this so the learning curve is near vertical!
Have a foot pedal and torches with both 1.6 & 2.4 options.
Could you give me some idea of the settings i should go with, and what
type of filler...
Hello All
Any idea's how best to 'weld' this? Bit of a project table.
Cross support is 30x10mm mild steel, the stainless steel mesh
is 1.6mm
I'm thinking brazing though i do have a Jasic Tig 200P ac/dc
Can't get a setting low enough so not to blow through the mesh,
but this is quite new to me so...
Hello
New to tig welding and have just bought a Jasic JT-200D, and i'm slowly learning the basics.
Have the standard supplied torch - WP26 but want to fit a smaller torch (BOC SR 9F) that was given to me.
Standard torch has negative output lead, spring loaded gas-in and torch switch connector...
Hello
Looking at an Elektromixte 400 TRI that i have come across and seeking some advice.
So far i have found out it's a French machine but had no joy getting any information from across the water.
Three phase, water-cooled, hand torch, no foot pedal.
Has been stood for several years and...
Hi
Looking for some feedback from users of ABAC Screw and Hydrovane compressors.
Does anyone have a ABAC Genesis that is new to them, or anyone who has had one for a while? Good points, bad points.
Depending on who i speak to depends on the answers you get especially if they sell one or...