Thanks for the reply. I've got in touch with AIE today for a price for the tandem hw16. Looks like some bit of kit, my only hesitation now is the price, as its significantly more expensive than the clarke twin pump, with the claimed same size, although clarke don't seem to publish the FAD...
How did you get on with this set up? I've been looking at the tandem Clarke compressors from Clarke, but not keen on the aluminium pumps. Been in touch with spares department at Clarke, and sounds like they don't carry a lot of spares on the shelf for them either.
I hadn't considered a set up...
I got in touch with the fellow selling the twin set up on gumtree, unfortunately it's sold already. Think I'll just keep an eye out on Gumtree for a wee while and see if another one crops up. That will give me time to get home from work, just to check what voltage I'm getting in the garage.
Just looking on gumtree, there is a Clarke xe37/270 listed for £750 that looks to be in good condition. What would peoples thoughts be on that? My initial thoughts are a little on the rich side for a used machine without warranty.
Anyone know any technical info on the xet19/200 Clarke Vs the xe18/200.
Not sure what the advantage is of the 3 cylinder over the 2. I'd guess the layout of the 3 cylinder will aid cooling
Cheers for all the replies chaps.
Just for general use in my home workshop, mainly working on old cars. I'm just slowly kitting it out piece by piece at the moment.
Biggest job on the radar just now will be sorting out the bodywork on a car. So biggest demand will probably be a DA, then...
I'm pretty sure I should be OK. When I built the garage a couple of years ago, we put in a very over rated cable from the main house supply (can't remember off the top of my head what size it was). I plan on hard wiring whatever machine I get direct to the consumer unit in the garage, and if I...
Hi folk, first time posting in a while, but been spending plenty of time lurking.
I'm in the market for a new compressor for my home garage, looking for as high a capacity as possible on single phase supply. Anyone got any advice on what to go for?
Looking at Clarke machine mart machines, and...
Did you ever get a transporter organised?
I've just won a Nissan Skyline in a raffle competition, and looking to get it delivered to Glasgow, from Norwich.