That was why I tried to remortgage a few years ago extend the garage and build an Orangery but this ruffled a few feathers and impossible demands were levied.
In the end, it did not happen I love the neighborhood it is very quiet, and when you wake up in the morning with birds and a bedroom...
That is my thought as well although in my lathe's case parts circled in red were in the extra cabinet, Initially, I just chucked in a drawer that holds extra unidentified bits that came with 2nd handmachines.
Now that I've identified the parts they will go in my dedicated drawer for the M250.
I...
Started disassembling the top slide today and the toolpost and top slide is soaking in in GUNK ULTRA ENGINE DEGREASER
Oil channels are dry but they had red grease stuffed in every nook and cranny
One on fleebay but is missing a few bits
Colchester Triumph 2000 Lathe Taper Turning Attachment crazy price but looks close to the one I have I thought the M250 and M300 had the same saddle dimensions
yep thought of that pretty sure will be easier but it will require the removal of the shelves at the back of the garage I have a few things to work out lowering the bench is not really an option as the tool Trolley adds a few challenges and I need to properly plan this.
I realize that the 3pase motor is more flexible but thought it was easier to deal with single-phase motors but what you say makes sense I am going to have a word with Newton Tesla and go from there.
On a further note, I have considered the options and think I will replace the motor with a single-phase motor £162 falls in the same bracket as a Quality Inverter
https://www.ebay.co.uk/itm/114122298139?hash=item1a9238131b:g:b14AAOSwxW9eRoqM
They do a Single Phase 4 pole with B3 Foot and D80...
There is a small mill :D but I have considered Aciera F4, Shaublin 13, Harrison 600, or a Boxford VM30
Not an option No one will give me a new mortgage at my age I struggled to get a remortgage a couple of years ago
I also have accessory 911/45 but it is missing D220H0001 anyone have a picture of one fitted I can't work out at the moment how this is meant to be fitted
I am considering converting it into a 911/48 if anyone has any details on parts 911033 and 911035
It is an up and over door
Moving the frame forward is not an option it is already pretty close to the front edge so this may compromise brickwork
I have considered the Roller door but that is reserved for Ladders and steps and weed eater
It is a bit loaded in there Sacrifices will have to be made
Today some cleaning and checking things out in the cabinet I found a few things that I did not recognise and could not figure out what it would be used for.
Also, the saddle looked a bit odd it is a bit gunky so, I had no clue what it was but after looking at the lathe accessories I realized...
I did consider moving the workbench down 200mm to fit the short bed M300 but considered it a bit futile as it will look a bit odd hence going for the short bed M250
Butt resistance is futile
When the rear cover is on it stops the garage door closings, so the table has to move, a job for...
A few years ago I bought a Myford ML10 specifically to make spacers for my motorcycle but it wasn't long before I wanted to try and make additional components but my little lathe was just not big enough.
I have been staring at the short bed M300 but I just did not have the space so I have to...
a couple of months ago there was an eBay add for a whole room full of Hardinge lathes I think it was 8 lathes in total for £2000 you had a week from sale to remove all if only I had the space