I think you could be right re the wiring,I bought this second hand and think that someone has wired it wrong, i have two lots of red white and black wires they are going to the live and neutral, they had live going to no 15 and neutral to 9/11.If I put the live and neutral to where it is marked...
Mike
I numbered all the wires and took photos when I disconnected the switch,so the wiring should be correct, I tried the switch out using a 12v battery charger,I switched through the from 0 to 6 without the fuse blowing on the battery charger,this happened when it was wired wrong!
Its...
Hi
I have had the switch apart several times and put it back together,if anyone wants to know how just let me know,it works ok, the only thing now is that, when I pull the trigger to feed the wire without any wire,the motor runs to feed the wire but it seems to be taking to much current as the...
Mike
Yes ,when in position 1 that is the the only contact made,and it's the same for the other positions,I have still to check which ones make contact when the bridges are in place.
Thanks again
Malcolm
Yes, i have the bridges on as they were when I removed them.
when I have the switch on 0 it is OFF.All other positions are ON
On SW Position 1: when I put the meter across 1+2 I have continuity
On SW Position 2: when I put the meter across 3+4 I have continuity
On SW Position 3: when I put the...
Did you get the switch sorted? I had the same problem,the switch was jammed, I took it apart with the same result as yourself,I have taken it separate and put it back together several times but need a drawing of the switch so that I know which positions the cams are in,I have made a perspex...
Does anyone have a diagram of the power control switch,it has 7 settings,0-6,or if anyone has an old switch that I could have so that I can get the settings off.
Thanks
Mike
The blue goes to 11 and brown to 15, I also have 2 reds,white and a black going to 16, and Red ,white & black to 14.I have attached a couple of photos which might help.
Sardine
Could you explain to me how you would take a picture of the cams inside the switch without taking it apart??????
I had taken pictures of the switch and marked the connections but that is not the issue ,once you learn to read ,maybe you will be able to come up with something constructive!!!
Yes, Ive had a look at this thanks,it's a pity this one only has the three banks,and I cannot see the contacts on my switch.
The good thing is, I now know how to change the cams,if I only knew which connections inside the switch went to which number on the switch
Thanks again.
PS: Is that your...
This is the switch I would like to know the connections for , I took it separate and put it together,but the cams inside the switch are not correct, ie what should number 1 on switch connect to in the switch,and the same for the other 5 points on the switch.I take it 0 will be off.
Hope someone...
Hi
I have just received this welder with a stuck switch, I managed to get the switch sorted but when I put it together I was not sure if I got the cams in the right rotation, when you take these apart the bits go everywhere ,it is a 6 position Kende switch 0-6, 4 bank.Does anyone out there...
Does anyone have a wiring diagram for this welder, i have taken the selector switch apart and need to know the correct order for the connections. (To rebuild the switch).
Hi
you would not happen to have a wiring diagram for this welder,my switch was stuck, I took it separate and the springs went everywhere,I got it all back together but I don't know if I have the cams in the right sequence,if you have a wiring diagram could you post it here or I will give you...