Sorry no pictures, cant get them off my Iphone. I took a picture with closeup lens and enlarged it, only to discover one of the signal (trigger) wires has also
been severed/ chewed up. The torch lead is crimped at both ends no chance of replacing wires. Decided against a quick fix for fear of...
This mig has a fixed (non euro connector) MXL 180 torch, it is the torch lead that has been cut into . It looks like only a heavy copper cable has been cut into.
I can't see the signal wire/liner/gas pipe,so presume rest is ok. Will strip tomorrow and see if I can pull wire from sheath.I'll let...
Yesterday,my son carelesley cut into my torch lead ! On telling me about it he said its ok Dad it's
only cut into the earth shield . When I looked it already wore a band of insulating tape! I said it has no
outer screen, anyway it appears to me that the power cable is half severed . My question...
When I make gates like this I never drill them. Admittedly I use round bar, I make a jig,a bit of angle
with a bit of flat bar welded on the angle, cut a big enough piece of angle out to pass over the
horizontal or angled bars. Clamp it to the lower upright bar and then insert the short bit...
I made some of these a year back and I used tensile steel strapping. Punched hole with whitney punch.
Important to flatten punched hole or it won't pull through.
I've done plenty of T2s never a T25, when I replace a for instance, a wheel arch I don't use the whole panel, just enough to replace the rot. That way
It leaves more of the better steel on the van, gives someone a chance to do the same job in the future, and creates an ofcut that you can...
I made a circle cutting attachment for my plasma held down with magnets. worked really well until I tried the minimum
diameter. The arc went sideways from the electrode through the nozzle and cap making holes where there had been none
expensive lesson!
Hot galvanising removes rust,wax,chalk but not paint markers! We send steel beams off to the galvanisers, the first time I wrote the customers
name with metal paint markers the steel came back with my writing perfectly legible no galv under the paint, oops!
May be you could paint the bits you...
AJN Steelstock Kentford Newmarket. www.ajnsteelstock.co.uk 01638555500
Suppliers of structural beams, columns, channels, angles, box,circular hollow and solid sections
ERW and sheet steel. Prefer big customers but will sell single bars, also have cutting service.
Will deliver for a small fee...
the peltier cell has a max temp before they get damaged (approx 345c), the stand on manufactured ones have a bimettal strip to lift the base away from the stove top in the event of too much heat.
Interesting post hotrodder thanks. As I'm not familiar with oxyfuel last used it at school I think I am going to find some sifbronze No8
and give that a bash. Originally was just going to cement it up to see this winter out but i'ts such a pretty enameled stove it would be sad to write it off...
There is no box just a plastic tube with a paper label no instructions , all I know is from the ezweld site and a MrTig u tube video
I wonder if the 90 year old stove iron is the problem. I'll give these rods a go on a broken garden ornament see how it goes.
I've had an IFL Fusion 200 PHF for quite a few years now. It has laid down 4mm rods one after the other all afternoon
with no problem . the fan is quiet , nice stable arc . Left it at my farm workshop where it was physically abused , gouge
in case proved this but no one conffesd. It is now...