I just got some from these guys a few weeks ago, and I thoroughly recommend them, it couldn't have been easier, rang up on the Monday and the bottles were delivered on the Wednesday, they deliver anywhere in the UK
I got the 20L (same as BOC size Y) bottle of Argon and the Same in Argosheild...
Barnett Welding UPdate
I see Barnet welding are offering, what seems to be an unbeatable offer, they doing an even bigger discount on the 10L bottles, either 25% off the gas price, or Buy 1 get 1 free, apparently you can get one as argon and the other as argoshield.
If you quote the Code...
Barnet welding Welding gas suppliers
I can vouch for Barnet welding
I just got 20 litre bottles of Pure argon and Argoshield Universal, (same as the BOC size Y bottles) they were the best prices I could find on the internet, they deliver all over the UK.
The bottles are filled to 200 bar...
Barnet Welding
I can vouch for Barnet welding too
I just got 20 litre bottles of Pure argon and Argoshield Universal, (same size as the BOC size Y bottles), they were the best prices I could find on the internet, they deliver all over the UK.
The bottles are filled to 200 bar, some other...
Open Source Bender Update
A Quick update for you, to show a bit more versatility
See the pic of the bender first and note the step in the angle
Then substitute that step for the one that I have shown below when creating a rib in a panel, such as a floor pan or similar...
Colin
The free version does pretty much everything the pro version does, except laying the drawings out and animations, and I think the pro version is only about £80.00, which when you compare that to everything else on the market is pretty good value.
Thanks for the comments re the RR...
Mark, thanks for your comments, can you send me the link for the Popular classics thread
Colin
I used Google sketchup, you can download it for free, it is very easy and intuitive to learn, with a huge support forum and parts library
Just type Sketchup into Google, but make sure that...
TBMW Open Source Bender
Eil
I think if I did it again, I would be tempted to make it slightly taller, as I have had problems in the past where it was not tall enough, or I have to tip it on its side and feed the metal right through the base.
Here are the photos of the 2 additional pieces...
Hello Guys, I am Tony who posted the thread on the Retro Rides forum.
A friend told me that you had built your own benders based on my design, I just wanted to say that you have done a great job, and due to popular demand I have just added some more details and sketches clarifying how I made...
John
Definetley a huge improvement over your first samples, I am intrigued as to why you think the left weld is too flat, flat is not bad, to me it shows good penetration, little heat distortion and less metal to grind off if needed, I would even try the next power setting up if you are going...
Hi
I am new to this forum but in my opinion you are almost there, I would recomend the next power setting up and just tweak the Wire speed up also. Turning the power up without the wire speed will normally mean that the wire will burn back into the shroud, and turning the wire speed up by...