Wasn't sure where to post , have a chewed up nut with some of the bolt sticking out , it's in an engine bay so don't really want to try welding a nut on top , question is if I use carbon rods say put one either side of the nut basically create a short will the nut heat up red hot ? Or do you...
Hi basically my compressor is in my hut and have a rubber airline going to the garage with pcl fittings , doing some painting nothing high end but want to remove the water from the line , looking to buy a wall mounted filter that I can connect to then the airline off this , problem is abit...
Hi wondering is it possible to weld round the sides of where the banjo bolt connects on a brembo brake caliper , mines has corroded at the sides , then have it milled flat or is that a definite no no , cheers guys
Hi does any have or know where to buy boilermakers chalk line ? The thin cotton line you rub the chalk on ,call me old fashioned ;) need it for work cheers
Got quite a few chips in the bumper ,so need filling , a wasnt sure what to use to stop the paint cracking with flexing it being plastic , would I use epoxy primer or just normal primer and the adhesion stuff ?
So i bought a 2nd hand bumper and side skirts for my Subaru , they need re painting from blue to silver , question is where do I start ? Do you need a special primer for bumpers ? A know years ago I used to use 1 k plastic primer but this will be done in 2k , not new to using 2k paints ,use them...
True a suppose the metal will move and get bigger never thought of it that way that's why a thought about Tig welding it but then thought would it cause a worse fracture it's a 2.0 Subaru STI engine
True a suppose the metal will move and get bigger never thought of it that way that's why a thought about Tig welding it but then thought would it cause a worse fracture it's a 2.0 Subaru STI engine
Well am a welder /fab to trade and my brain tells me metal expands when warm so crack should seal but my mind runs riot tells me it will cause problems lol