Thanks for that, I have sent you a pm :cool:
Absolutely determined to get to the bottom of this fault ;)
At least you used to be a professional Radio ameteur .... The best I could do was an old am/fm CB radio .... 1:4 for a copy & all that :ashamed::ashamed::D:D
Many, many thanks for...
Morning chaps
Good morning to you all :cool:
mr migwire, thank's for Ceboras contact details, i'll get an email off to them next week .... You never know, they may oblige me with a schematic of the PCB :whistle:
I would say that the welder is every bit of 20 year's old now :o
Been out...
Yes mr migwire it certainly looks the same .... First thing I done whe I bought it was to fit a euro socket & decent torch.
I seem to remember it cost me a small fortune at the time :o
Will try to get out to the worshop tomorrow, get the test meter out & have a delve into the Cebora...
Me too ;)
If I want to reduce the brush marks on seam sealer. I take a 1/4" fine haired brush, dip it in celulose thinners ( Gun wash will do nicely ) & flatten the seam by brushing with quite a wet brush ... It'll leave quite a neat finnish.
Just don't let it drip onto fresh paintwork...
Cheers mr migwire
Yes one of the voltage regs was changed .... TIC126D
The one just above the relay in the centre looks to be a similar component to a voltage reg ( 3 pin with an eye for fixing to board or heatsink ). Can't read the markings as they face the relay.
Either a used part or...
Hi Eddie
Thanks for your reply.
I am almost certain that the original & replacement pots were the same.
The only marking on the original pot was 2K2 , after a bit of research I understand that this relates to a pot value of 2.2 k ohm's
The replacement pot other than being Blue in...
Hi all
Second post & in need of help so soon :o
The PCB on my ederly Cebora Auto Star 180 ( Model: 838 )Mig welder, looks to be dead :(
Here's the story so far.
A couple of years back the wire feed became erratic( Feeding wire at full rate ), it was noticed that if the wire speed...
Hi
My name is Ronnie & live in the far West of Cornwall.
A more or less life long welder/fabricator, most of my experience is in the marine & agrucultural industy as one would expect in this neck of the woods.
That said I have done a fair amount of structural steel work whilst working...