I've had an m-pro 252 for a couple of years and it's been fine.
I have used it on aluminium and the settings were good...i now keep a seperate...
My 3 kva welder/generator won't quite run a 3.2 rod on my Lorch H150 at the end of a 50m extension.
I've been using a Lorch H150 for around 10 years.
It's been fine and i've had it on a few extension reels with no problems.
From what i understand the industrial ones are only good out to 10 yds compared to the outdoorsie type ones.
That sounds like a good range....
What is it to be used for?
I have a Flir scout, had it for quite a few years. Things have moved on a bit though since then and they are cheaper....
I use a 6 slot charger. They are great for overnight charging of a few batteries.
For the sort of stuff i do i think i'm better off with lots of 5's at £60 than one or two 9's or 12's at £200.
If i'm buying a new tool i usually...
It looks like the 12AH's take nearly 5 hours :o
I have about 6 of the 5AH's if i put one on charge it'll be ok before i run out of the others.
THe 9AH will be 1 1/2 hours on the fast charger and 3 hours on the standard
A bit more exhaust stuff.
Finished the inside..the spacers will hopefully hold it together a bit.
Slid the outer bit on...needed to...
That sort of cleaning work needs to be designed out nowadays.
Have the grizzly bars and one side of the hopper pivoting and a ram or hoist to...
Does the bottom of the plunger connect to a foot operated bar to switch the lathe off?
Started on a stack pipe for a Massey 6490 all in stainless.
The inner is 3 1/2" the outer 6".
Just tacked together until the right...
Will the plastic "nut" also have an integral detent arrangement to hold the choke in the up position?
One of a couple of mora's and something else locking.
A Fallkniven PXL
No problems...just buy it over the internet and it get's delivered to the house...no need for certificates etc.
A resin table top....either brass chucked in randomly or standing up to make patterns.
Rimfire or Centrefire?
I have done all my medium risk courses with Mines rescue as well.
The plan was to do it on the lathe and have circlip grooves................it ended up with a rotabroach for the holes and welding a washer in to...
Separate names with a comma.