might know a man who could laser cut... how many you need?
A busted vernia after being clumsy.... luckily it wasnt one of my good ones[ATTACH]
depending on the length of cable between vfd and the motor, local reactive load is sometimes needed to stop breaking motor insulation
where i work...
does you job ever take you to norwich parm... if so visit wexs
last tank i did.. phos acid, hot water rinse then a rinse with either ethanol or methanol...
seemed sucessful at the time
smaller coin cell with a threaded cap made in a lathe.. glue threaded ring in to suit
Face fit test is the way to go
not aquired today, as it came the other week
been using it, and finding it a bit Jabberwocky
today i freed up the brushes in one of the motors so both...
got a proper picture of it?
how many would you like?
2nd hand but nothing as nasty as yours
if you are levititating, who needs steps?
butt weld surely leaves the most steel in the joint?
round up......... saves on batteries
wide band lambda and a innovate display would give you a clue as to how rich, if you are prepared to weld a boss on the exhaust before the first cat
Found in a ditch near where I was working.
Not sure on the brand?[ATTACH] [ATTACH]
knocked on a door of a house with a skip thiscevening on the way home, and got this for the workshop... would have liked more time to delve deeper...
if you want to consider 2nd hand, i have 2 110v that i keep meaning to list on here..
where i used to work we used industrial hand soap to clean pistons.. smearbo , leave overnight...
big enough blip to get me 5 hours callout
Separate names with a comma.