Did they at least cough?
Label maker for Xmas perhaps?
Snap-On has a kit that comes with the left twist drills and extractors.
All I bought was a bigger tap wrench a #4, 3/8 - 1” or M9 - M27 it’s a good 20” long.
Someone here must have a second half with a Cricket machine or maybe a men with shed type of makerspace .
I was told to just use winter antifreeze for rv pipes on my 351 Miller.
I would check the wire roll it sounds like it is overlapping then snapping if it is you may have to let it unwind some by suspending it. I’d feed...
Those work quite well I have one in the garage hooked up to a plug in thermostat that can be used if it’s too hot or cold mine...
Is there any chance of compacting the soil maybe use a sledge.
My 73 Norton Commando came with shoulder height ape hangers as stock with a curved banana type seat / low sissy bar.
My Dad could write with both hands forwards, backwards, and mirror and they all looked the same!
Me I’m a lefty but shoot right golfed left.
I use the dollar store superglue / green tape for work holding on the Haas mill and to repair a thumb nail that was destined to pop off now it...
Needs to be cast upon the waters?
My dad told us about using carbon tetracloride poured down the carb while running.
Put some oil down the plug and after sitting a few days try rocking it in gear
Looks like a Burgo derringer I had years ago 38 special?
It’s all fine and good till someone siphons the diesel out of it! I’d hate to pack my own fuel in a electric vehicle to run a generator that will...
My god! If it’s tree less are those weeds in the background?:scared:
That’s going to be a nice shop!
You could always save your arms and go air over hydraulics on it.
Basically I was just wondering if it would work with brass out of curiosity I would like to try this in the near future.
Separate names with a comma.