@Paul. Do you cut the hearth with plasma? By hand?
Nice lovely project.
Have a nice stainless evening.
How warm is it on full power?
How do you persuaded the 30x30 to fold precisely on the edge, without twists?
The holes on the horizontals are for water or for the galvanizing?...
Almost no noise and precision good enough to weld without problems (for me , at least).
7024, it is my dream to find 5 of them, just to try.
Have you tried to contact them directly?
Make a lot of photos of the light tower.
And write a long post in the project section :thumbup:
A contactor similar to yours has (for the coils):
- inrush power 70 VA
- hold-in power consumption 7 VA...
You are right about Fro, they are in Lincoln group:
I don't think, but I know little about the market.
They are just the 3 "hobby level" wires that I know. ;)
I have never tried flux cored wires. I was looking to buy some and play.
I often look to Ine, because they are local to me.
Anyway, removing the...
These are the "ingredients list" I watched:
lincoln nr211mp http://assets.lincolnelectric.com/assets/EU/MSDS/en-GB/SDS4661.pdf
Hi to all.
In this time of holiday, I spent half an hour reading Ine datasheets for their
self shielded flux cored wires.
(Mainly INETUB S71T11...
If I may ask (the VFDs are almost a magic thing, for me :( ):
What are the rules on sizing the correct resistor for an application?
Ops, I meant 10mm, sorry.
Yes, without backing plate.
Did you leave a flat spot on the bottom of the 10 mm plate or did you bevel them to a sharp edge?
On the rare occasions I try welding such...
Nice book. I bought it last year.
Thanks for the answer, @TechnicAl .
I have found some good Video on Youtube.
To change a little menu, I am looking for old fashioned books now.
Even University level can do.
Is the white one a Dyane 4 or 6?
I started after trying TIG at job.
It LOOKED easy, neat and a very cool thing.
So I tried my father's aircooled stick welder and glued something...
Separate names with a comma.