Guerhing make nice stuff. Mt4 countersink must be a lump
Seamless wire doesn’t pick up moisture
You need to try a different ndt outfit.
Where were you sending your test pieces. Even TWI aren’t that expensive.
I might be buying a proper one soon and will be selling my motor and vfd
That Mitsubishi VFD is the one I've got on my welding rotator.
Only a potentiometer for speed adjustment. You don’t have to have jog and all that stuff
You just need a three phase motor that runs on 220v.
Wiring up a VFD is pretty simple.
It takes the 220v single phase mains and converts it to...
2.2kw is about 3hp isn’t it?
I wouldn’t heat it too hot with the propane torch that would do more damage than good.
If it was me I would just steam clean it with the karcher...
I’ve run ESAB machines on synergic and it’s still not been right. Literally 1V can be the difference between worm tracks and not.
@Richard. Page 5 mate.
I saw a guy on instagram managed to do some dc tig with a magic wave? TBH people that rave about Fronius stuff usually are coming from basic or...
Edit: Just seen you are running Pulse. You'll definitely need to turn that off.
Yeah, don't run Flux core on synergic lines. There are so, so...
Voltage too high. Arc length too short.
Well I’ve jumped those two purple wires in the connector block and we have power!
Forward is reverse though but that’s easy enough to fix.
If you look up arc auto sport on Facebook send him a message he builds lots of cages. He might be able to give some advice.
So since I picked up the lathe in September I haven’t even plugged it in.
Electricians came this morning and wires up the new old stock MEM...
I might do a little video of it and put it up on here as we are constantly getting these sort of cast questions.
Sometimes, even modern vehicles,...
Separate names with a comma.