These are worth a look. https://www.toolstation.com/sip-meteor-2300-automatic-welding-helmet/p32517 Got one recently to replace my old parweld...
When I first saw it I thought it looks a heavy duty build. Then when I saw the skip for a weight I thought it's going to tear itself apart. I know...
But isn't there a nearer whirlpool formed at Dorus Mor that may be more likely heard at Crinan?
Buckler wellies are good. I see they do a ladies specific version....
I sold my early round head Student with two chicks and vfd drive for £1300 last year so I'd say £500 is very reasonable for that. Certainly...
I had a Skoda Octavia with the 1.9 TDI PD engine. Timing belt went after a pipe on the fuel filter cracked and sprayed the timing belt area with...
To get the fit of top and bottom halves good my suggestion is: Make the bottom half first and weld up nice and square. Top half leave the "flaps"...
Beautiful backdrop ruined by an eyesore of a building in my opinion. But I've never seen anything I've liked in bare corten steel. Best left for...
Corten steel sculpture with multiple failures, lead to its eventual removal. Hate to think of the wasted tax money....
Depends how.much.stuff you've got to blast and how quickly you want it done. Single phase compressor not worth bothering with. Large three phase...
Isn't there a material you can place inside the tube to stop it collapsing then warm it and it melts out? Can't remember the name of it. Not sure...
Don't think I'd be lifting a lathe I valued with an engine crane well not one of those type anyway. Going to to be difficult to keep the bulk of...
Hasn't that just rotted into the ground? Literally.
What about the axle locating peg that protrudes from top of leaf spring and locates in the corresponding seat on underside of the axle? Without...
As far as I'm aware VFDs don't like running an output to no load so as long as one motor is always running it should be OK to leave some of the...
Take a Chainsaw to the tree. A new one will soon grow back.
12m reach machine for £10K is going to be difficult unless it's very poorly I think.
That was my thoughts. Although hire cost wasn't too bad it was the hired in plant insurance requirements that killed it over £300 a week I seem to...
I'm about to put my Sambron up for sale after finishing my building. 2 tonne lift but only a 6m reach though. Been a good machine with no...
It shouldn't matter that the adjustment pins are soft they are only used to align the loose headstock which should be full tightened down again...
Separate names with a comma.
