Seems like some opposing views
I really don’t have the option of moving the engine back so il just have to try to move the rack as little as possible.
Great it will be 20mm tops so hopefully it won’t causes a massive change
so without a huge knowledge of suspension and steering dynamics its going to be a bit hit and miss
Im currently doing an engine conversion and i need to space the steering rack out a bit for clearance. Im estimating around 15-20mm and possibly...
ive had a bottle of co2 from them for ages that i used for brewing, as you say when the deposit has dropped to 0 there is absolutely no incentive...
I have used them in the past
There not really rent free bottles as the deposit is on a sliding time scale so if your not using a lot you will lose...
As said pretty dependant on your quality of work, how busy you are and location
I would also expect a quote for a specific job not an hourly...
Yup I didn’t think of doing it gradually. Thought it may twist the metal but doing it in small increments would probably work
I’ve seen a press break that fits into a hydraulic press but all in your looking at £500
Nothing massive 20-30cm at most
Anyone know where I can get one that will bend up to 2mm sheet and doesn’t break the bank ? Only hobby use so it doesn’t have to be anything special
Yup clean cut. Like I said if I feed it through manually and then tighten down the tip all the way it doesn’t move unless I loosen the tip a...
Yup tried removing the tip and when I put it back on it would feed but not if the tip was fully tightened
0.8 wire and tip
Just purchased a new parweld 171c.
Trying to feed the wire in and it keeps jamming at the tip ! Feeds fine up to that point but just doesn’t want...
go under a few names
search for, vice mounted press brake or vice brake
I purchased a cheap rx8 a while back as the engine was on its way out, trouble starting when hot, Had a bit of fun in it until it didnt want to...
Yeh I think I could get 2 of the bends done on one of those but would have to slit and weld the last one
Yes I’m going to brace down the middle. It was just a rough picture for shape
That may be use for some of the bends and cheap enough to justify giving it a go.
I was looking at a small brake press but don’t think I’d get the 2 bends that are close together in tight enough together. Slitting and weddings...
Separate names with a comma.