Some of the Dexion draw units are made by Lista, the tall one in the left corner is Dexion....
To be honest I never knew what they were, it was a sealed bid job where an F1 team were relocating and these were surplus to requirements.
"why don’t you do it this way" May offend whereas " is there a reason it cant be done like this" may not.
I bought twenty one lista`s for £250 :scared:
I think the general consensus on any of this type of work is to get it classified as "essential repairs too" and not improvements or a new...
All you need is a short term mobile storage unit :thumbup:
Twas a generalisation Mr Sparks :laughing:
Ye of little faith :vsad: All but one are now in the workshop and used daily, one left to house and that will go in the new barn being built...
I think I have mentioned this before on here somewhere, a few years ago we were all hauled in for an HS dressing down by a major forestry...
Old men dont bounce :vsad:
I have a LSD rear diff out of a 2wd landy festering in the container, apparently they fitted them as standard on all 2wd landrovers. It needs...
There are hole saws made for the job https://www.3keego.com/en/product/detail/CORE-DRILL/HAA-Rebar-Cutter
Landrover axles run quite close to the bump stops as is, slamming it 2" will bring the axles even closer to the stops making it a bit of a harsh...
The 160/180 Autostar for reference
Its a rebadged Cebora autostar, you wont have any grief ordering spares from Cebora.
My vote goes to uplighting :thumbup:
I acquired a couple of new 5mts mig torches, one MB25 Parker for the Esab ( very nice) and a gurt MB36 Starparts ( not so nice)for one of the big...
There you go, break it up for spares. There are enough folk on here restoring these things to sell off the good bits. :thumbup:
A lot of pallet companies have trucks with a Moffet up their chuff, they are non too shabby off road and are more than capable of picking up...
Its a bad design, most short log type manifolds that closely bridge exhaust ports have unwelded socket/spigot expansion couplings. I would be...
Separate names with a comma.