building inspector out yesterday, passed with no problems
It’s all within building regs.
Staircase was fabricated in my workshop and the rest was done on site
I think itS hole size larger than the thickness of the materials punching
Recently been on site punching 18mm holes in 152x152x30 rsj with no problems. Much faster than a mag drill and a lot less mess as well.
I’ve not seen any with a larger throat than 100mm even in the smaller range. But for cost wise I wouldn’t get the smaller punch as it reduces the...
Depends more on thickness/material of the plate. Punching 16mm hole in 8mm stainless was just over 7000psi.
But 14mm hole in 12mm mild steel was...
It’s handy as I go on site with it, park my van next to the steels and punch away. With a 100mm throat it can handle most jobs
That’s the reason I looked at this set up, an iron worker is way to expensive for me where as this set up was much less than £500 including a...
I just recently punched 16mm holes in some 8mm thick 316 Stainless plate, it was on its limits but much faster than drilling.
Just thought I’d give an update on this hole punch.
I’ve had it since April last year and it’s pretty much worked every week, and the only...
Same job as the last post just a bit more
The skull is made from half moon shaped stainless sheet.
Rolled a bit like you would do cones
And the wife laughed a lot
Thanks, was just asked for a Viking ish mask. Started with paper and wire template then just made it up as I went along
Just some replacement parts from 316 stainless for a fishing boat based at Seahouses Northumberland
Was asked to make a exterior light.
Made from 316 stainless with a led down light inside, just waiting for the green polycarbonate to turn up
Separate names with a comma.