Looking good. Enjoying reading this.... keep it coming!
Apologies if this is something of a thread hijack.........
That looks like one of those magic eye puzzles!
On the group page Andy would start a thread and when he posted start people would comment with a bid.
After 30mins Andy would then post Stop and...
Look good. Ordered.
Gone for a £20 Amazon jobbie. If I'm not happy with it when it arrives it can just go back (has reasonable reviews though).
Just need gloves and...
Mig180 arriving Monday via the Redvictor Facebook group.
Thanks for the heads up.
Cool. Thanks for the suggestions
Seen some circa £20 on Amazon but suspect they may be slightly pants.
Happy to spend a bit more if it translates to a...
Cheers for the replies, the bidding went a little higher than I was thinking so....... Bought a new RtechMig 180 instead!
Caddyshack has some handy hints!
Cheers. I suspect I will never get near the upper reaches of the available power!
In a kind of general way would the above be a reasonable choice for a first welder to learn with?
Intended use (once I've had a little practice)...
Something like that.......
It also turns out that I can borrow a Clarke Mig welder from a friend for a little while.
Gives me an excuse to drop the rear subframe and give it some love!
Nothing too bad needed, the car is a w201 190 1986. There are a few common areas that rot, this one has them all!
A previous owner used the filler...
Hello, potential new novice welder here....
A rash purchase of an elderly Mercedes has identified a need to either find a friendly local welder...
Separate names with a comma.