arther dailey
Member
- Messages
- 5,991
- Location
- England
I use 4m torch for everything just saves constantly moving machine/bottle,no feed troubles whatsoever
Thank you Tom that's very kind of you.I'm popping some spares in the mail for you tomorrow, just something to get you started
Im no expert but your runs look somewhere near....suspect your travel speed is a bit erratic, gence the different weld profiles. Possibly raising and lowering the torch slightly.
I find i get far better results using two hands left to steady the torch, other on the trigger. Have a practice run of the route.
I know, but I feel bad that you had to go out and get a 3/8 nut because for some reason it wasn't in the package so it's the least I can do to cover your time etc..Thank you Tom that's very kind of you.
I hope you realised my little dig re the spares was aimed at GYS, not you
I've hardly even scratched the surface of its capabilities but I believe it's a great machine and I'm really pleased with it! The wire feed alone is something I'd only previously dreamed of! Lol.
Received today Tom, thank you very much, I really appreciate itI'm popping some spares in the mail for you tomorrow, just something to get you started