Peloquin
Member
- Messages
- 565
Hope someone can help..
I have some 30mm plate with a 14'm clearance hole drilled.
The boss is asking if we can drill the out to 18mm.
Obviously this would leave a piece of metal 6mm either side of the hole.
Is there a minimum requirement of untouched steel between the edge of the hole and edge of metal?
Cheers folks.
I have some 30mm plate with a 14'm clearance hole drilled.
The boss is asking if we can drill the out to 18mm.
Obviously this would leave a piece of metal 6mm either side of the hole.
Is there a minimum requirement of untouched steel between the edge of the hole and edge of metal?
Cheers folks.