Hi guys,
I have done several mods to my machine following the info already contained on this site and have managed to create a decent machine, but I've got a technical issue that is beyond my electrical skills to diagnose. So I'm hoping that someone on here can keep me right and point me in the right direction with this fault?
Mods so far.
1. Euro torch fitted (working fine).
2. New 12V relay fitted to the pcb (working fine).
3. Industrial motor and wire feed fitted (working fine).
4. Separate 24V transformer for the wire feed motor (not working fine).
I have just fitted a 24V AC transformer with a bridge rectifier and now the wire feed wont adjust down, it is running flat out at 24V? Everything else is working fine, the motor stops and starts as the trigger is pressed. I have connected everything back up as it originally was and its still the same? I have taken the PCB out but cant see anything burnt out or damaged?
Please help before I take it outside and drive over it, wish I'd kept my Sealey 130 turbo now.
I have done several mods to my machine following the info already contained on this site and have managed to create a decent machine, but I've got a technical issue that is beyond my electrical skills to diagnose. So I'm hoping that someone on here can keep me right and point me in the right direction with this fault?
Mods so far.
1. Euro torch fitted (working fine).
2. New 12V relay fitted to the pcb (working fine).
3. Industrial motor and wire feed fitted (working fine).
4. Separate 24V transformer for the wire feed motor (not working fine).
I have just fitted a 24V AC transformer with a bridge rectifier and now the wire feed wont adjust down, it is running flat out at 24V? Everything else is working fine, the motor stops and starts as the trigger is pressed. I have connected everything back up as it originally was and its still the same? I have taken the PCB out but cant see anything burnt out or damaged?
Please help before I take it outside and drive over it, wish I'd kept my Sealey 130 turbo now.